Astm a354

Grade of Fastener and Surface Finish. A is defined as fasteners for application at normal atmospheric temperatures, where high strength is required and for limited application at elevated temperature. Users should note that A and A are not exact equivalents to the structural grades in this specification. This abstract is a brief summary of the referenced standard. This indicates that A Grade BD can be an alternative for Grade A bolts if the requirement is for something other than heavy hex bolts with standard structural bolt thread lengths the mention of A is related to F Grade A

Uploader: Nazil
Date Added: 3 September 2010
File Size: 66.50 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 73857
Price: Free* [*Free Regsitration Required]





Heads of ABC bolts will be standard hex, while AB7 will be heavy hex unless otherwise specified. Unless otherwise specified, the grade and style of nut for each grade of fastener shall be as follows:.

This abstract is a brief summary of the referenced standard. Hardness, tensile strength, yield strength, elongation, and area reduction shall be tested to meet the requirements prescribed. F Grade is the highest strength of the three grades within the F specification, which covers steel anchor bolts intended for anchoring structural supports to concrete foundations.

AB7 fully threaded studs and heavy hex bolts are widely available in the marketplace.

Historical Version s - view previous versions of standard. The intended application for F is a35 an anchor bolt, and F Grade covers a slightly narrower range of diameters than A This indicates that A Grade BD can be an alternative for Grade A bolts if the requirement is for something other than heavy hex bolts with standard structural bolt thread lengths the mention of A is related to F Grade A Astk Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Grade of Fastener and Surface Finish. A is defined as fasteners for application at normal atmospheric temperatures, where high strength is required and for limited application at elevated temperature.

Alternatives

Unless otherwise specified, the grade and style of nut for each grade of fastener shall be as follows: Nut Grade and Style A. There are some differences beyond just the intended application though. This specification covers the chemical and mechanical ashm of quenched and tempered alloy steel bolts, studs, and other externally threaded fasteners. Bolts manufactured under this specification are intended for use in structural connections.

ASTM Aa - Haydon BoltsHaydon Bolts

Selection will depend upon design and the stresses and service for which the product is to be used. Also note that F Grade has a maximum tensile strength of ksi, while A has no maximum. Link to Active This link will always route to the current Active version of the standard.

Any alloy steel capable of meeting the mechanical and chemical properties set forth in a54 specification may be used.

A354 Bolts

No other units of measurement are included in this standard. Users should note that A and A are not exact equivalents to the structural grades in this specification.

ASTM A is a fastener specification covering alloy and stainless steel bolts and threaded studs for use with flanges, valves, pressure vessels, and fittings for high temperature and high pressure service. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. All fasteners shall be made from alloy steel conforming to the chemical composition requirements.

2 thoughts on “Astm a354”

Leave a Reply

Your email address will not be published. Required fields are marked *